It really depends on what you’re doing, and you’ll switch back and forth a lot. If you’re say, punching in over a particular section, you’ll want it off so that when you finish the recording, the transport goes back to the beginning of the section so you can hear it. The left arrow is pointing to the Link Timeline and Edit Selection button, and the right one to the Insertion Follows Playback button If it’s not on (which is the default unless you change it in the preferences), then the playhead will go back to the point where you started that particular playback or recording. If it’s tired on, the playhead will remain at the point in the Timeline that you hit stop. If you don’t know how Insertion Follows Playback works, you may be mystified by what happens after you hit the stop button during playback or recording. Understand Insertion Follows PlaybackĪnother aspect of the Pro Tools GUI that’s important to understand is the Insertion Follows Playback button, which is two buttons to the right of the one for Linking Timeline and Edit. The key command for it is Shift + Forward Slash. Luckily, if you activate the Link Timeline and Edit Selection button, then any edit selection will be reflected in the Timeline, and vice-versa. Because the Timeline selection governs the playback stop and start, separate selections can be confusing for new users. In Pro Tools, you can have independent edit and Timeline selections. The Link Timeline and Edit Selection setting To turn it on with a Shortcut use Command + Option + 1 (Mac), Control + Alt + 1 (PC). When it’s active, you can use numerous single-key, keyboard shortcuts, such as R for zooming out, T for zooming in, N for Insertion follows Playback (see below), and many others (look in the Pro Tools Shortcuts tab of the Help menu to find out more). If you click on it, it turns yellow, and you’ve just switched into Commands Keyboard Focus mode. If you look on the upper right of the tracks display in the Edit window, you’ll see a little icon with “a-z” on it. Using the Smart Tool means you don’t have to constantly put in a Shortcut or press an onscreen button to switch editing tools. When that happens, slowly move your cursor over the correct area until you find the spot. Sometimes you think you have the cursor in the right place to change to the tool you want, but Pro Tools doesn’t seem to want to switch. When it’s on, the curser turns into a little icon representing the tool that’s active at the moment. Toggle the Smart Tool on and off using Command + 7 (Control + 7 Windows) or by clicking on the horizontal bar just above the three edit tools in the Edit window. Depending on the cursor position, the Smart Tool can change between (from left to right) the Trim Tool, Selector Tool, Grabber Tool, and a Fade tool
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |